Here I am

Recent Content by jakitt

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. J

    anyone come up with a good way to mount their Dipricol fuel pressure isolator?

    AC--did DiPricol replace the defective isolator with a new diaphram type? Did they charge you for it? Do you have a contact phone number and address for DiPricol? I was told by Diesel Power Products that DiPricol doesn't make their own fuel isolators and never did. Diesel Power Product's...
  2. J

    Engine/Transmission (1998.5 - 2002) fuel pressure guage isolator problem

    Does anyone have a contact address and phone number for DiPricol? My isolator crapped out and leaked diesel fuel into the cab; luckily I caught it before it made too big of a mess.
  3. J

    2nd Gen Non-Engine/Transmission best pillar gauges?

    Diesel Power Products--DiPricol guages... very high quality! Isspro guages are also excellent. Kitt
  4. J

    2nd Gen Non-Engine/Transmission 2011-2002 Dodge factory 16" 8-hole steel wheel widths

    Thanks guys for the info on the wheels!--jakitt
  5. J

    2nd Gen Non-Engine/Transmission 3500 vs 2500

    2004 2500vs.3500 differences There are several differences: heavier overload rear springs and an 11. 5 ring gear on the 3500. For the $100. 00 additional cost go for the 3500! Might even be the same cost. --jakitt
  6. J

    2nd Gen Non-Engine/Transmission 2011-2002 Dodge factory 16" 8-hole steel wheel widths

    Does anyone happen to know what the wheel width is for the stock Dodge factory steel wheels 16" diameter 8 hole for 2001-2002? I'm looking for a set of 4 to mount some M/S tires if they are 8" wide. Thanks!
  7. J

    2nd Gen Non-Engine/Transmission 6-speed shifter knob removal

    tHANKS GUYS! i APPRECIATE THE HELP. --JAKITT
  8. J

    2nd Gen Non-Engine/Transmission 6-speed shifter knob removal

    Does anyone know how to remove the shift knob on a 2002 Dodge Quad cab without cutting it off? I need to remove it so I can install an aftermarket knob. Also, is the shaft threaded, and if so, what type of thread size?
See more
Back
Top