Recent Content by JeffBecker

If you don't have some good greasable u-joints in there you should get them now. And check your ball joints.

I did look for a slot to adjust the brakes, but didn't see it. I will look agin in the morning when I get home from work. Thanks

When I step on the e-brake it just goes to the floor. I did try taking up on the adjustment, but that didn't help. Im thinking there my be something broken inside. Last week I changed my rear service brakes. That is when I tried to remove the rotors. The rotors are still in good shape, so I...

I'm having a problem with my parking brake. On my 2500, do I have to pull the axel to remove the rear rotor?

It is most likely the rubber tube between the door and body. It is a tight bend for the wires inside there. What you will probably find is wires that have been bent back and forth,and now have broken.

That looks like a very helpful link, thanks!!

Count me in!!!!!!!!!!!!!!

3+ weeks ago I had a head light out. I pulled the bulb, but was OK:confused: I checked the ground-OK had no power to the low beam. Went to start the truck, and nothing. It would start and run for 3 sec. then quit. Sounds like the security system, right? Well had it towed to the dealer. They told...

I have an 06 g-56, and have not seen any more than a little bit of gray film on the plug. It has 116,000 on it,and on its 3 change with Royl Purple. As for the noise,it's hard to hear any little noise over the DD clutch.

I think I have a rear main seal leak. What is involved in replacing this? Why did this fail already? I have 110,000 on the truck. Thanks

I have the 3250 DD sprung hub in my truck, and love the darn thing. It has very light peddle pressure. I have the upgarded hydros too. I went from their 3600 DD to the clutch I have now, and it is a pleasure to drive now!! My 5' 100 lb daughter can drive it all day long ( if I would let her:) )

You my want to check your crankcase vent, if you haven't done that already.

I had a problem with my Southbend clutch, call Peter, and he went above and beond for me. I don't think you will ever hear of anyone that has had bad or even so so costomer service for Southbed clutch. Jeff

I think you have one or more fingers broken on your pressure plate. This happened to me ,and it sounds just like mine was shifting(or not shifting). You need to call Peter at Southbend . He will take good care of you.

You can look around and get one used. I bought one used, and love it. Even if you have a problem with it, Edge will take good care of you!!