Recent Content by jjolin

Well the dealer replaced the lift pump and the truck runs like a champ. I aqree that if the vanes blocked the fuel flow the truck would quit running. Only explanation i could think of. I was alittle scare after reading other posts and they said there truck would at least start and run if you...

Truck died today. I figured it was the lift pump but after reading seaches on the subject, it seems the truck should run with a dead pump. My question is did anyone's truck die and it was the lift pump? I turn the key and the lift pump is dead. It have about 31,000 miles on it. It's at the...

DavidC what were your numbers after you replaced your pump?

The fitting is 1/4". I sure wish they would of said something in the instructions about threading the hole. Most of read 20 different instructions because i wanted to be completely some i didn't screw it up. I did tap the threads all the way down. I going to try maybe washers as spacers or cut...

I used anti-seize but that doesn't help snug the fitting up. If i left it flush it's sloppy and i'd have blow-by. I had to screw it down to tighten it up. I quess i could have the fitting cut and rethreaded so it wouldn't protude into the manifold. Wouldn't look forward to redoing this project...

installed EGT probe today Drilled and tapped the manifold and screwed in the fitting and had to turn it down quite a ways to get it to tighten up. The bottom of the fitting isn't flush with the manifold and sits about 1/4 below. Is this a big deal? Is there a heat treated type of plumber tape...

Tonight i looked at the pipe fitting sleeves and replaced them. I think i over tightened them. I wasn't sure how much torque to put on them. I didn't get a chance to test it out but the sleeves i took out were twisted and the tubing was restricted. I'll post the results. Tomorrow i drill and tap...

What kind of boost pressures should i be seeing? The only time i see a reading is when i got my foot in it and it verys depending on with gear i'm in. I see about 24 max with an ez and elbow. Should i see anything at idle or if i'm crusing at 70 in fifth gear? Or only under a load. I guess i'm...

Where is everybody mounting the amplifier box for the EGT gauge? Inside the cab or in the engine compartment? I'm about to install my EGT and boost gauges and the instructions are vague. The boost gauge came with no instructions. I also need the instructions for drilling and mounting the probe...

So Jason if i set it on the first power setting its the same as the EZ and the other three settings are used with the pump wire hooked up?

The instruction manual says Power Edge EZ Plus.

Yea it's the edge EZ plus. I'd just like to know what the settings are if i don't hookup the pump wire. It has 4 power level and 4 boost level settings. Any help?

Does anybody know the settings for the plus? I want to run it as a regular EZ without the pump wire installed for now. Also where is everbody mounting the unit under the hood. I think the edge people should be giving us more info on the product. I was disappointed with the lack of spec's...

I could also use the instructions to install my injectors. I get the 275's from catdiesel and no instructions came with them. Thanks Jeff -- email address removed --

Thanks for the info. Can't wait to get my truck setup with the new add-ons i've purchased. I only have to wait 2 more months and I'll be back home. Thanks, Jeff