Recent Content by JThorsten

Oops thought this was my post

Forgot this add was up. Sorry items are gone.

The seat had been sitting probably 6 months over winter thile I was redoing the truck. The. motors worked a little bit then quit.

The motors don't function to adjust the seat. As far as I can tell they gave up. Can a guy buy new motors or does someone have other suggestions?

I actually found a schematic diagram at the local dodge dealer

I got the speakers and seat figured out. Sept the motors are junk. Trial and error is a hard way to do things. I kind of figured out tue dome and cargo light, but sure how to properly wire it in. Wasn't able to get the brake light work.

Can anyone help?

Its not completely finish. Only a couple items left. Has a blown 383 stroker, newer 5spd trans. Hydraulic clutch. Oak bed with s/s trim. Complete frame off restoration. Local shop did the body work I did everything else. Runs and drives. I just don't have enough time to enjoy it. I'm currently...

I put an 01 cab on my 95 frame, I'm using the old dash. Is there a wiring diagram so I Can blend the harness's to make the rear speakers, power to the seat and 3rd brake light work?

Any interest in trading for a restored 69 c10 p/u

still have?

no problem, sharp looking truck

im looking for these parts, im not selling them

axles sold. but i have a set of doors, full power, but one door has wires cut. and a passengers front fender for sale. $25 each. pickup only unless your close

any interest in your truck plus some cash towards a restored 69c10