Recent Content by kjg26

Also what other circuit could I use?

Can you provide some further details on where this is located. You're suggesting depending the plug and swapping the 2 wires? Also can you provide a wiring diagram for that.

I've posted about this issue before but it is still unresolved. I have code p0871. 2016 ram 2500 with 68RE transmission. The valve body has been replaced twice now with the solenoid pack and everything else. Internal the transmission looks spotless. I'm told it could now be a PCM or wiring...

I looked and looked. Couldn't find. Spoke with Fuel. We figured it's a 20x9 with offset of + 1

Alignment round two. Trimmed the inner fender and mud flaps by about 6 inches and I'm good to go.

Trimming the mud flap and the inner fender seems to have worked.

So adding a spacer would add negative offset? And I need more offset?

Would a small spacer help with my issue ? Like 1/4in?

Ok. I believe the wheel to be a 20x9 with +1 offset. I've trimmed my inner fender and will be going for a test drive shortly.

View of drivers tire from above.

Mine extend out past the factory fender flare by maybe an inch. I'm going to see what I can figure out from FUEL.

How can you tell the amount of offset?

170k. Mixture of towing and hwy unloaded.

I just picked up my truck from tires plus. They installed 295/65R20 Toyo AT3 on my 16 ram 2500. I provided them the Thuren alignment specs. This is what I was given back. I am returning tomorrow to have their master tech give it a go. Thuren specs for my truck is the second line. Lasty i...

And......this is why I bought a pan with a drain plug. Ugh