Recent Content by Lone Watie

I believe the entire hub/rotor/bearing assembly needs to come off on the 2nd gens. Others will chime in...

I think that's air dog's intention to place the sender there.

Every now and then I throw a P1291 - No Temperature Rise Seen From Intake Air Heaters like this evening on way to work, only on start up. I usually just reset the CEL and go on my way, but curious if anyone has experience with this code, or what I could check. I'm guessing the intake grid...

I took these numbers from my service manual: Oil Pressure (min) Note: CAUTION: If oil pressure is ZERO at curb idle, DO NOT run engine. At Idle Speed 10 psi At 2,500 rpm 30 psi Regulating Valve Opening Pressure 65 psi They are slightly different from cummins ISB owners manual...

That's what I thought. I wonder if the Oil Pressure numbers are correct, though.

Looking at my diagram above, seems that the capacity is a little high... 17 qts... is this correct?

Hope this helps:

Try again below...