Here I am

Recent Content by Mikcon

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. M

    help I need a stock 05 downpipe

    Can anyone help I need a stock downpipe for 05 6spd. ASAP help if you can. Mike 440-897-8121
  2. M

    Pacific Performance Engineeering programmer

    contact me. Pm or email
  3. M

    Pacific Performance Engineeering programmer

    I run it and love it. I have tried the bullydog and I like the ppe better. I have it stacked with the juice and ez so it should stack ok with a banks, but have never tried it.
  4. M

    how much rail pressure needed to start?

    BoB4x4 is this like looking for brass magnets?? I don't know what a skim system is.
  5. M

    how much rail pressure needed to start?

    I did take all boxes off. that was first thing. Good news and bad news. Good news today it fired bad news we did nothing else!!!! My buddy has some computer software for trouble shooting and it was able to get into the can-bus. We plugged it in set up everything we wanted to see and when...
  6. M

    how much rail pressure needed to start?

    I have 1/2 tank diesel (not gas if you mean gas) I think you mean wrong stuff and thanks but nope. Any way to fire injectors?? Am I right thinking my cp3,Fuel pop off valve,and lift pump should be ok if I have this kind of pressure just cranking the motor over? Also do you think the...
  7. M

    how much rail pressure needed to start?

    With a scantool (snap-on read under generic obd II) I was able to get 9500 or so psi. but truck still won't start. If this is enough pressure what else could keep the truck from starting. Thanks, Mike
  8. M

    4 digit injector tip number

    Thanks. everyone
  9. M

    4 digit injector tip number

    I have a 05 any one know what the number should be. Trying to find out without pulling them. I think I need some new ones. Thanks, Mike
  10. M

    turns over but won't start...Help

    Anyone have any other ideas?
  11. M

    turns over but won't start...Help

    Came home running fine. Went out to start to run up town and real long crank and then started did it twice. Now it will only crank. Anyone out there help. Here is what I have tried: Took off the juice,EZ, and took ppe out back to stock on pcm Took the fass out buy hooking up factory pump...
  12. M

    Archived crank no start

    I have fuel and batts. are good. Anyone have probs. with the crank/cam sensor?
  13. M

    Archived crank no start

    checked and found code p0628 fuel pump low not real sure what code means. fass pump seems to be working. disconnected edge and flashed ppe back to stock and still crank no start any sugestions would be great.
  14. M

    Help how much boost should I be able to hit??

    The viper was crazy. You could lay on the go pedal at a 110 let the funny fuel flow(300 shot) and you could lay black strips just a haze but a real good time. Vipers should run that way. Trucks just don't seem like they should run like some I have seen on this site. The truck is just...
  15. M

    Help how much boost should I be able to hit??

    Studs and o-ring are next on the list. I was just courious.
See more
Back
Top