Recent Content by notmeofficer

Um.. Im stupid... I missed eight,I thought it was nine.. thank you for fixing my old eyes

The engine plate says 190 HP @2300 rpm It appears the Allison might not be the way to go because of no overdrive.. I may have to look for an OD manual to match Here is a picture of the ENGINE PLATE. I do not see anything that is nine digits. ( but I misread it was 9.. and not 8...

Hi gentlemen Thank you for your guidance The frame is a 1979 f600 4 x4 The cab is a 1956 Ford Super single Michelin xmls are 46 inches tall A 60 mph truck would be adequate...a 70 mph truck unecessary I will try to reread the engine number I have looked at some pics of a motor out of a...

Thank you everyone for your advice The gears are 6.20s. I will probably run super singles in the end. The 22.5s are over 40 inches right now The main build is on FTE https://www.ford-trucks.com/forums/1582730-beastie-56-79-f600-4-x-4-a.html#post18807888 It has a sub forum on the 56 forum for...

Yes it is 4 x 4... I own more than one It has Rockwell a fd75 7500 pound front axle and h106 18k rear axle. They are equipped with 6.20 gears. I have a new set that came out of my fire truck, fully built sitting in the shop with Detroit lockers front and rear. It has 15. X 4 in h front brakes...

Tha Thank you.. Will check

My 1956/1979 Ford F600 "Beastie".. currently in frame off full resto. It is 4 wheel drive. This is the last truck I will restore in m y life after many fords and several F600s I bought a 1994 5.9 intercooled TD 5.9 out of a medium duty 1994 4800 Intl School bus.( I got the wqhole frame slice...