Recent Content by prodiesel

05 w/59,000 miles new door seals , rebuilt trany , several programing updates , bright light indicator light blinks on low beam , Sirius radio that won't connect all the time , now a fuel guage that doesen't work . But all in all it has been a great truck and done everything I've asked and more !!

Hooked up the scanner and it said fuel level is 72% ( The tank has 5 gallon of fuel in it )and an APS relay output circuit open . Did a cluster sweep test by holding in the milage trip button and turning the key on , all the guages swept like normal . It came up with a code AD16 . Can anyone...

The 9mm has a much smaller grip width than the 40 and fits smaller hands better . What ever she gets make sure she gets comfotable with it and just know if you get it out be prepared to use it . Don't get shot with your own gun .

My fuel guage on my 05 went to empty and the light came on just after filling up . Every once and a while it will read correct then back to empty . I pulled the tank and the sender sweeps from 220 ohms to 20 ohms , there is battery voltage and a good ground at the connector and I don't use the...

Replaced the relay and starts every time THANKS AGAIN

I'm not getting pull-in voltage at the fuel shut-off sol. every time I try and start it . It's a 97 1 ton egr engine . Replaced the shut-off sol. , where does the voltage come from for the pull-in on the sol ? The starter only has 1 big and 1 small terminal on it .

Installed 2" spacers from Revtek part #702 about 2000 miles ago. It took about an hour or so to complete with no special tools. My 05 cc LB 4x4 now has 22000 miles on it and has not been alined and no issues yet.