Recent Content by Randyc613

If i could find the wiring diagram for the truck i might be able to help but its been almost 2 yrs since I did this. I don't remember the details but turn and stop light functions are seperately wired. You'll need 2 lights on each side of truck, wire 1 to tail and turn signal, the other to tail...

I see that piece, what I'm asking about are the little dark lines the arrows are pointed at.

06 truck, mileage at 240k, trans was leaking at torque converter seal so I dropped trans, the 8 pin plug has had signs of leakage for a while also so i dropped valve body to change the inside harness. While inspecting for things that might break soon, I didn't see much but, noticed these small...

No, the truck wiring plugs into the factory tail light assembly. No plug to cut off.

The resisters I used were part # LT05-650, I got them from one of the upfitters, not sure the brand. They just plug in at the light. Had to fab a bracket to hold them, they do get warm and will melt things that can melt if in close proximity. It took 4, had to have one for stop and turn...

The CM bed is pretty nice, build quality seems high, the finish looks good but I'm not sold on the powder coat finish, it has let loose on some of the sharp edges.

Just flatbed swapped my pickup, put a CM brand bed on my 03 3500, after 2 weeks of being told "just cut the plug off the truck and hard wire it" I found a better alternative. Part number is 112-854 taillight wire harness/pigtail. brand is APSG, I found it on Amazon, I think it's for guys...