Recent Content by RobertHiltz

Did any of you folks stop at the place that sells pizza by the pound when you were in that area. I don't remember the name of the town (maybe Idaho Springs). I worked that area of CO. for several years testing mostly Rams and Jeeps. Many Sundays in the summer I would run our mountain routes with...

Loggers don't need to worry, there will always be a need for paper.

Truck Vehicle Development used a valve that was on the top side of the oil filter housing. It was easy and quick to draw a sample. No mess, just enough oil for the sample.

Hi Nick, You should be up here, no sand blowing at all. Did get 2 foot of snow over the weekend though. Bob

There is a unit that has 3 female plugs at one end of the 3 foot cord and a single male three prong on the other end. The male end goes into a recepticle that looks just like a 7 wire trailer recepticle with a mounting bracket that is mounted in a opening of your front bumper. It has a spring...

Said hi to Paul for you. Last weekend was our polar plunge days where they cut out a big chunk of ice from Lake Bemidji and people go swimming (very short swim) and we had a PB look alike take the plunge too.

You must be in or near the oil patch. Lots of people from this area are working in that area. A good friend of mine is working on the natural gas line from canada to supply gas for a small refinery. I think his man camp is in Tioga.

First time ice fishermen usually get a little uncomfortable hearing that noise while out on the lake.

Bemidji, MN Looks like we will get to -30 tonight. Just went out and filled the stove with wood again. 1:15 AM

Our wind chill today was -50, our daytime high was -12, our overnight low will be -25 or colder. This will be the third night in a row of -25. Not near as cold as it used to get years ago!!!

Oregon bar and chain is what I use.

I have a heating system like you are asking about. You will like it. Do some research on the various methods for below slab designs. Some use a deep layer of sand (several feet) without the insulation board in the center area of the slab, most systems are like described in the above post, my...

Bob4X4, Thanks for the info.

Thanks Bob4X4 hope you find it.

Just had the dealership do the J35 recall update. My recall notice said it included a software update for the EVIC too and that the dealer would print instructions for the changes to the EVIC. I did not get a print out and cannot see any changes to the display. The dealer service guy said the...