Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
TDR Magazine subscribers receive more than the magazine! You also gain additional forum privileges!
Details here: TDR Privileges
Subscribe to TDR Magazine here: https://www.tdr-online.com/
You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
Recent Content by sscribner
Attention: TDR Forum Junkies To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.
A couple of years ago I remember seeing a post that showed a fifth wheel landing gear brace that mounted to the frame to brace the gear. After many searches I have been unsuccessful in locating the post, does anybody remember who made this part? It braced the extended gear rearward and inboard...
Thanks for that link, that was very interesting reading. My lift pump was dieing and replaced under warranty with the new in tank pump. I found out the hard way that the fuel sender does not read the same as before and ran out of fuel before the gauge even reached the empty mark. I guess I will...
The september Popular Mechnics mag performed a test with the Tornado as well as five other milage enhancers (magnets, ionizers) and all of the were found to decrease the actual HP output of the test vehicle and did nothing to improve fuel milage.
I use a pintle hitch for my jeep trailer all the time and all the heavy military trailers use the hitches. The hitch is noisier that the typical ball hitch as the ring can move back and forth in the pintle. You should be fine on the highway, look at the next dump truck that goes by towing a...
I recently arrived home from a 3 week 6000 mile trip pulling our fifth wheel and noticed that the compressor side of the turbo housing is now a toasted brown color where it was silver before leaving on the trip. Is this normal and nothing to worry about? I have installed Rip's 4" exhaust...