Recent Content by TDeltonto

i found that there is a bushing and a seal but they are both good. no lift or recent alignment. thinking maybe a u joint but they look good and i cant get them to move by hand

the truck is a short wheel base. is there a bushing in the tail shaft?

there is a clicking noise coming from the rear of the transfer case on my 2005. i have checked the u joints and they r good on both front and rear drive shafts. the noise sounds like its coming from the tail shaft. is there a bearing or some thing that can be changed in there? it is also...

i copied this from bluechipdiesel.com "The ECM and OEM Injectors and Cam Sensor never give any problem in my experience. In fact I have never even heard of these components being bad, even at crazy high mileages, so they don't need further consideration, unless this diagnostic sequence fails to...

any one????

blue chip diesel says he has never seen or heard of an ecm failing in the 1998. 5 to 2002 trucks

quick question how do u release the electrical connector on the back of the vp. i cant get mine to release

i am having the same problem. thats the way mine started and now the truck only starts every so often. i have done all the tests u have. i just havent had the $$ to fix the truck. but every thing ive read has said its the vp. could it be the ecm??

if no codes were set for the vp could it still be my problem? truck cranks all day long but wont start. connections are all good and fuel to the vp still just wont start. Starts occasionally but not for the last three months. any ideas?

i still need my vp44 fixed just dont have the $$$ right now

yea i usually let it cylce once and then i turn off the ignition and let it cycle again its been pretty cold here

check engine light came on following codes came up 1693,1694, 1698, 0232, 0234 (which is boost to high) P1694- (M) No CCD Messages received from ECM Bus communication failure to PCM. P1698- No CCD Messages received from PCM Bus communication failure to PCM. A 9Companion DTC9 was set in...

Can anyone refer me to/or does anyone know of a good mechanic around the grand junction/ montrose area in colorado

had the injecter nozzels replaced. they are all tight and mechanic said they were good

i did the pump test and got about 1 quart