Recent Content by torqmakr

Did not notice any drone at all this this setup. Believe it or not the cab is as quiet as stock. Has a nice sound while in to the throttle. I don't know if it's just me, but the truck seems to have better throttle response and faster spool up than before.

MBRP Muffler kit Install Just installed the MBRP muffler kit on my 04. 5 and it turned out pretty good. The hardest part was taking the stock muffler out. Pain in the #@*, but doable. Just had to trim the tailpipe some and the extension pipe that was in the kit a little bit to get it all...

Its the trans overflow from probably being too full, should be no problem. Spray it down with some cleaner and keep an eye on it.

I have noticed that if you coast alot(less braking) you will better numbers. Try it out it seems to work.

Its a problem with the lock mechanism. The dealer will replace. Make sure you get a replacement lock mechanism with AG after the part number, this is the corrected part.

I researched them all and I went with Line-X because it seemed more durably than the others. Alot depends on the installer because I seen alot of bad spray jobs. No complaints with Line-X. I have some before and after pictures if you would like to see. Good luck.

Something to check is the brake switch. If there is any play in the switch it will cause the cruise to not set, thinking the brake is applied. If you can get it in this mode you are talking about pull over somewhere safe and out of traffic and check to see if brake lights are on without touching...

There were alot of vehicles last year at the port of baltimore that were ruined by a hurricane. I seen them and they were to be scrapped I believe. So this kind of thing does happen. Sounds like Chrysler is doing you right by getting you into a new one. Good luck!

Thanks for all the input.

Has anyone used the TAP electronic brake controller on their trucks. I installed one (new) and getting an intermittent first led light on on the controller. Tried another new unit on other trucks and it is still doing the samething on the others too. 1. 04 volts output at the tow connector. Is...

I have noticed that around the 60-65 mph range makes a huge difference. Coming home from work the other day I seen 20 to 22. 2 on overhead . I love my new truck! This thing so far is great. Is there such thing as a Cummins/RAMaholic ? If so I think I'm one.

Just came back from a trip from detroit to atlanta, 3 adults, two kids, 1 dog, and about 600 pounds of stuff in the bed(don't wan't to do that again!). Driving 70 plus mph and on the way down averaged 16. 5 to 18. 3 on overhead. Slightly less on the way back. 2200 miles on the truck right now...

The internal plates idea mentioned above sounds like the issue here. I have seen one blow up in an individuals face just taking the cables off the post due to this same thing. Not very common thankfully so.

Do you have an aftermarket alarm? It looks like wiring for alarm or other add on.

Anyone have, or heard of Nasta's Stainless step bars? Any good? Thinking of adding but not sure. Any info would be great. Thanks in advance.