Recent Content by TSeran

My 95 3500 seems to have lost its MoJo. When I kick down the throttle to downshift, I have an automatic transmission, it doesn't downshift. I used to get 20+ pounds of boost and that too is gone. I suspected the cable from the foot pedal to the injection pump and found that there were a half...

One of my rear flared fenders on my RAM 3500 is damaged. I bought some fiberglass repair, but when I looked closely I could tell the fender wasn't fiberglass. So, off to TDR to find an answer. Now I've confirmed that the flared rear fender is in fact plastic and not fiberglass. Does anyone...

Got to be careful that you don't push that plunger into the housing too hard. It will ruin the switch. Good luck.

How much were the tires at Discount? And what is the stated advantage over the standard LTX model? Thanks

Hi, I know this was posted some time ago, but I was hoping you might answer a few questions: 1. Where did you jump wires 3 and 4? On the brake switch? 2. Where did you find the brake light switch for $15? 3. Would it do any good, or damage, to spray the switch with contact cleaner? Thanks...

TS Performance MP-8 Contest Entry Please include me in the drawing. I am a contagiously enthusiastic guy everyone wants on their team. Thank you:)

What about the AFC springs? Will they effect the towing performance?

My transmission will shift down, seemingly just a half gear, whenever I tap the brakes. For New Yorker that drives with two feet, this is very annoying. Any idea why this occurs? Also, given my upgrades, do I need to upgrade the AFC springs or the govenor springs for better acceleration when...

I have a 1995 3500 4wd. The upgrades are an AFE cold air filter, a 4" straight through exhaust, a #5 torque plate and a 16cm turbo housing. My questions: 1. What is the highest SAFE EGT I can maintain while towing? I have been told that after 1250 things start to melt, and that 1350 "all...

I have a similar problem I think might do well in this thread. I have a 1995 RAM 3500, turbo-back 4" exhaust, ATS cold air intake, #5 torque plate, 16cm non-wastegated housing, pre-turbo EGT gauge, transmission temp gauge and boost gauge. Black smoke and the deep sound of the engine lugging...

Recently, while cruising through town pulling my 6 ton beast, I had to make a couple of very quick stops due to other drivers ignoring my presence. No problem, I rebuilt the brakes and had a good feeling while lurching forward and catching the flying dogs. The right front brake pads started...

I brought the drums in today and had them turned. Tomorrow morning I leave Colorado for Texas. I'll let you know what I learn. Also, when I removed the drums today the shoes were tight against the drum so I know the adjusters are working (I adjusted them 6 times). Still haven't looked for...

Great minds think alike... ... I just wish I was one of them. I visited the machine shop today to have a broken bolt extracted and discussed the brake issue with the machinist. He too suggested bringing the drums in and he would turn them for free. So as soon as he extracts the bolt and the...

I just installed new drums, shoes and wheel cylinders on my 1995 3500 dually and still have some "grabbing". Everything was cleaned, anti-seize on all recommended spots, and adjusted to where the drums just fit over the shoes and drag slightly. I also bled the lines until new clear brake fluid...

I have a 1995 RAM 3500 dually 4x4. I cannnot find the torque specifications for the rotor to hub or the caliper to hub. Thanks, Tony