Recent Content by TurbineDoc

No codes, I'm able to read codes with my Insight 2 monitor.

No I went with Air dog after the algae issue in Feb, dropped the tank cleaned out rinsed with water & denatured alcohol, let dry, and reinstalled tank, also have been treating with Bio Kleen

I think I know the answer, I'm looking for 2nd opinion, with $$$ of injectors I don't want to guess wrong. My last trip to my camp I was driving my 06 3500 4x4 dually, & whenever putting load on truck i.e. hill climb, or running above 71 mph, I would get an audible chime alert ans grid hearer...

Fuel pump was running, yesterday my running mate pulled and cleaned the MAP sensor, loaded with the same trailer load as before, he went on a test drive, power restored, accellerated as before , little smoke, and "hill climb" to 80 mph without issue. Thank You for responding

As title of post says losing power, no codes, fuel filter changed, 2nd one in 2 weeks 1st one changed for pre trip maintenance, I did not see that filter myself. "Rest of the Story" this past week we have been using our 05 Dodge 5.9 dually, in support of a Southern Baptists disaster relief...

When I get back to US I'll be conferring with one of my marine diesel buddies that works for MTU and see what their recommendations are, also the Caterpillar rep that worked at same shipyard I used to work at.

Other than the PS bio-kleen which ranks #10 on this list https://gobestdrive.com/best-diesel-fuel-algae-treatment/?page=2#compare any other recommendations/experience from it, or stuff to "run away from"?

Thank You I will be checking into this when I return from Argentina & back in the US. Some good FYI here https://crankfix.com/algae-in-diesel-fuel/

Agree ergo better fuel filtration and biocide once I identify which will provide best protection.

Thank you again to all that have responded, I'm in Argentina now working on that ferry I posted info on. Unless bio fuel added/blended to our pump fuel unknowingly I'm running "normal" #2 Diesel fuel, and when I travel away from home I do not used any bio-D marked pumps. Again I do not know if...

More pics apparently I'm limited to 4 per post

As we used to say in USN Post Op Test Sat (post repair operational test satisfactory). I went on a short road test this evening maybe 5 miles round trip, truck performing as it was before I started having the high rail pressure issue @ idle see attached photos of engine data: Noted there is a...

Success or at least looking that way, much improved I still need to go for a test drive. Thank You all for the remote tech assist. I will update more after test drive. Clean fuel & new FCA was the ticket, no fluctuating rail pressures up to 1476 engine rpm have a look at the attached photos...

It is unique , based on a catamaran hull (2) 30Kshp turbines each driving a water jet in each hull, dual fuel ; Diesel & LNG that gets expanded to gas fuel once vessel is underway for greener operation and has enuff heat energy to "boil the liquid gas" in a heat exchanger in each GT exhaust...

Wow as I start peeling back the layers of the memory banks how this has transpired, I have been dealing with this since last October in some degree. My truck is not a daily driver it was bought to pull our Church disaster relief ministry equipment trailer (hurricanes, floods, tornado recovery)...