Recent Content by vrt93

So these storms in Texas recently have accelerated the deterioration of my clear coat, mostly on the hood and front fenders, and the paint elsewhere on the truck isn't exactly showroom quality. I'm toying with the idea of painting the truck with bed liner. This thing has 430k+ miles on it so I'm...

Howdy all, I've received countless help from this forum so I thought I'd give back with my solution for a fuel pressure gauge from the tank to the cp3. A while back I was trying to diagnose a starting issue and had a rail pressure gauge set up, but nothing telling me what was coming into the...

Ok, so I think its solved. Ended up giving Todd at T&C Diesel a call and after a long conversation about the symptoms and what I've done so far, he suggested replacing the CP3. Took a gamble and so far it seems to have solved the issue. I have to take the truck out of town tomorrow so that will...

I guess, but its a brand new HpTuners. I also installed my old non-bosch FCA and checked it again and same target duty cycle but now the actual is reading 2-3%

Somebody help me with the logic here: Just got HPtuners hooked up and was messing around with the truck idling when I noticed that for the FCA duty cycle, when it was requesting 40% at idle, the actual duty cycle was like 1600%. Is that just indicative of a bad FCA or a bad pump?

Anyone know what these are or what they go to? Couldn’t seem to trace them back to anything.

Sorry to resurrect this, just managed to get some time to look at this this past weekend. So cerb, you're saying it might need a new TIPM? Ohm checked the coil and it's right at 4 Ohms, so I don't think it's a compressor issue. All the grounds seem fine and i'm not having any other issues that...

Not sure on lift pump pressure, but I verified that it was working and pumping some amount of fuel up to the filter/cp3. Unfortunately I've been waiting on some alignment dowels for my flywheel housing to mate up to the back of the engine block so I can finish installing my new clutch, but from...

My bad, Didn't realize this wasn't the first page. scrolled back and found it. Rookie mistake

What was the part number(s) for the kit?

Very helpful, thanks! Looks like the part I was looking for was 04429068 for anyone who finds this in the future

I'm in the process of installing a new clutch, and while the trans was out I decided to install a new rear main seal. While putting it all back together, I'm noticing the flywheel housing has a little bit of room for movement. there's no dowels or anything to align it and I cant seem to find...

Ok, so I got a volt meter on the LP side switch and couldn't get continuity on any two pin combo (there's 3 pins for the switch). I'm just wondering why the LP side was building pressure with the compressor off?

Disclaimer: I know very little about A/C systems (enough to fix very basic problems) and I'm going off of logic here. Rundown of the situation: A/c stopped blowing cold air recently. Fan comes on, but the snowflake light wont. Sometimes, if I leave it on, the light comes on and it will blow...