Recent Content by WillRoach

I usually fill up on friday, come saturday the price always goes up at least . 10 cents in the west Michigan area.

It was the water pump well I took it to the dealership and they determined it was the water pump. I see that there are a couple other threads on here that mention folks are having water pump failures at low milage. What i found interesting was my truck never overheated or had that smell you...

Hello folks, I noticed a small spot under my truck this morning and upon further investigation i noticed a small droplet forming on the ac compressor bracket. The fluid is clear when i wiped it off with my finger and has a oily feel to it. At first i thought it may be condensation but the...

Hello folks, I have a 1979 cavalcade 20 foot travel trailer. I trying to troubleshoot some electrical issues and was wonder if I was supposed to have continuity between ground and the neutral bar in the electrical panel? Any advice would be helpful! Will

Are there any instructions on this? and are there any mandatory replacement parts that need to be replaced if I do this Job? i would hate to get in to it and realize i needed to order some parts. Thanks Will

Thanks everyone for helping me understand! Will

Any one else notice a difference on how the exhaust brake works with the Tow/Haul mode is turned on? My truck seems to slow alot faster and the exhaust brake stays engaged at lower RPM's then when the tow/haul mode is on. When it is off all i get is some noise coming from the turbo and very...

Hello all, when i am constantly on and off the throttle in heavy traffic and the exhaust brake is on i notice a pop coming from turbo side of the engine. When I disengage the exhaust brake i don't notice it anymore. All the components in that general area of the engine seemed tight and i didn't...

sag2, I believe I may i have done this. I went and doubled checked my connections and realized the air temp sensor was not connected fully (tight spot). I will assume this is my issue, thanks for the reply. Will

Good evening folks, Just installed the S&B CAI on my 08 2500 and followed the instructions that came with the Kit. Once all was back together I went to start the truck and noticed that the CEL stayed on. Pulled the codes and three came up 1. P2228 Barometric pressure circuit low 2. P2580...

31943/874: 36. 5

Thanks folks, I will make note of it. Will

Went and started the truck and at first i had 14volts on the gauge. after about 10 seconds of idling the volts on the gauge dropped below 12 and the lights all went dim. this did this back and fort between 14 and below 12 a couple more times before i finally took off for work and it leveled out...