Search Results for Query: *

Thanks Thanks for the reply. I am going try it and see if it works. It should work.

I have an early 04 3500 with a six speed and I want to put a factory jacobs exhaust brake on it. I want to put an 04. 5 exhaust brake on, for the 4" outlet so I can run 4" exhaust all the way out the back. Early 04 had a 3. 5" outlet. With all my research, I have found that it should fit...

I have been running Bridgestone Dueler Revo on my '00 2500. I regularly haul a 7,000 lb tag along and a 10,000lb gooseneck. I live In Colorado and deal with snow all the time. I like the way the Revo's handle with the trailers and in the weather. I have about 15k on them and they show very...

Same problem I just went through the same problem. I just installed my new gauges from Genos 2 weeks ago ( awesome service). Fuel pressure was 8 psi idle and 0 psi WOT. I installed a new transfer pump from Napa. Pressures went to 14psi idle to 6 psi for a few days and then the new pump went to...

Check your exhaust manifold for loose bolts. I had a similar problem a few months ago. I lost the 2 rear exhaust manifold bolts and I had no boost. The manifold was whistling real bad as the pressure would vibrate the manifold gasket. There is a TSB for manifold bolt locks to be installed, if...

similar problem Your front end is engaged by a vacuum pod on the front axle with a sliding fork and collar internally. The vacuum pod is on the pasenger side of the axle. I would check for a vacuum leak at the pod first. Pull off the vac lines at the pod and check for vac with the engine...

Found the problem It took me a while but I found the problem. I had power coming out of my controller,but it was not making it to the 7 pin connector. I found a short in my wiring where the trsiler wires go above the spare tire. Apparently, the spare tire had pinched the trailer wires to the...

Thanks for the replies. I will test the ground on the controller and check the wiring on the trailer in the morning. Matt

I am going on my third track bar in 55k. I am interested in changing out the ball joint design track bar. Where did you get the bracket you used for the 3rd gen track bar.

Today I hooked up my trailer to haul some parts and my brake controller quit working. I have a '00 2500 with a tekonsha voyager brake controller. I have been using this setup with my trailer for over a year and have had no problems til now. I have power to my controller on the red wire. I...