Search Results for Query: *

In the video Grumpy8811 posted, the mistake that guy made was not getting the gear hot enough and not having a toaster oven right by the truck, so installation is quick. Looking on another forum the guy says the gear had to be heated to 450-500 degrees (350 degrees didn't work for him) and it...

I have looked on another forum and seen just what has to be done. The cam gear needs to be heated for removal and installation. I figured as much. Kind a like replacing a ring gear on a flywheel. I'll watch your video also. Thanks for your help.

I have removed the fan, belt and idler tensioner. Cleaned the area. Operated the engine and verified that is where the leak is. The leak is getting worse. I can't stand the oil all over. I scrubbed the area with a tooth brush a brake Kleen. I applied some gasket maker hoping it would seal, but...

Have a 2016 3500 C&C with 125000 + miles on it. Oil is leaking from the RF lower corner of the gear case. All of the cover bolts are tight. Can the cam gear be pulled off so the gear case can be removed? Or does the cam have to be pulled from the engine to remove the gear case because there is...

To put an end to this (sorry it took so long to get back) and make a short story of it. it was the pressure sensor. We replaced it and the transmission has been working properly for a month now. I'm glad it was this simple and fairly inexpensive.

As stated above, I did check the pressure sensor connections. They are clean, but I did apply dielectric grease. Thanks.

My 2015 Ram 2500 with 68RFE transmission (44000 miles) threw a CEL. Pulled the codes and they are P0933 pressure sensor range performance, P0869 Trans fluid pressure high and a P0935 Hyd pressure circuit high output. ATF looks good. I checked the pressures sensor connection, and it is clean...

I have thought for a long time that the EPA and CARB use a bate and switch policy. Certify you today (aren't they doing the tests and certifications?) and fine you tomorrow. Emissions are big business! I'm surprised the after market guys like Banks, BD and others haven't been find even though...

When this happened, it was actually fairly warm, say in the 40's. I'll keep your advice in mind.

I have been doing a lot of local deliveries over the last 3 days. I have put on about 400 miles. The truck has not missed a beat. Boost has held steady when cruising on the flat (9-11psi) and has increased when pulling hills depending on load as much as 23psi. I let the truck do the work and do...

I thought about that. Maybe a bad spot in the pedal. Today I have started shutting off the traction control each time I drive the truck to see if that system could be the culprit. Won't be driving it much until after Christmas.

I'll set my gauges so I can monitor boost. Located in upstate NY, so elevation isn't an issue.

Maybe the engine isn't quitting, so to speak. but the truck pauses, coasts or whatever you want to call it. Just is not a good feeling. I'd think if it were in the transmission or drivetrain the tach would jump up when it happened.

I do have a cheaper scanner, but not alpha OBD.

Yes, buy filters from Geno's.

Have not been watching boost when it happens. it's so random, never know when it will do it. I will watch boost and hope I can see something.

Looking back in my service records, it was actually serviced @ 89500 mi, not 92359 as I stated above. Sorry my mistake. I do not go to the 15000mi interval. I watch the dash gauge indicator and usually average around 11000 mi between services. Right now filters show 12% so service will be...

All were change when I serviced it last @ 92395 mi. I always change the fuel filters @ the same time I do the engine oil & filter. It is about due for another service.

Truck has 100,539 miles on it. It is stock except for the City Diesel actuator (replaced @ 88000 mi) bought from Geno's. Over the last month, four times I have experienced a sensation like the engine is quitting. After accelerating and then leveling off to a steady speed the engine seems to die...

2nd Update: Ram called on 3/30/16 and said they will reimburse me for the full amount. Just waiting for the check at this point.