Search Results for Query: *

  • Users: kjg26
  • Order by date
Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. K

    P0871 not valve body

    Also what other circuit could I use?
  2. K

    P0871 not valve body

    Can you provide some further details on where this is located. You're suggesting depending the plug and swapping the 2 wires? Also can you provide a wiring diagram for that.
  3. K

    P0871 not valve body

    I've posted about this issue before but it is still unresolved. I have code p0871. 2016 ram 2500 with 68RE transmission. The valve body has been replaced twice now with the solenoid pack and everything else. Internal the transmission looks spotless. I'm told it could now be a PCM or wiring...
  4. K

    Tires, alignment, and rubbing

    I looked and looked. Couldn't find. Spoke with Fuel. We figured it's a 20x9 with offset of + 1
  5. K

    Tires, alignment, and rubbing

    Alignment round two. Trimmed the inner fender and mud flaps by about 6 inches and I'm good to go.
  6. K

    Tires, alignment, and rubbing

    Trimming the mud flap and the inner fender seems to have worked.
  7. K

    Tires, alignment, and rubbing

    So adding a spacer would add negative offset? And I need more offset?
  8. K

    Tires, alignment, and rubbing

    Would a small spacer help with my issue ? Like 1/4in?
  9. K

    Tires, alignment, and rubbing

    Ok. I believe the wheel to be a 20x9 with +1 offset. I've trimmed my inner fender and will be going for a test drive shortly.
  10. K

    Tires, alignment, and rubbing

    View of drivers tire from above.
  11. K

    Tires, alignment, and rubbing

    Mine extend out past the factory fender flare by maybe an inch. I'm going to see what I can figure out from FUEL.
  12. K

    Tires, alignment, and rubbing

    How can you tell the amount of offset?
  13. K

    Tires, alignment, and rubbing

    170k. Mixture of towing and hwy unloaded.
  14. K

    Tires, alignment, and rubbing

    I just picked up my truck from tires plus. They installed 295/65R20 Toyo AT3 on my 16 ram 2500. I provided them the Thuren alignment specs. This is what I was given back. I am returning tomorrow to have their master tech give it a go. Thuren specs for my truck is the second line. Lasty i...
  15. K

    68 rfe fluid and filter change

    And......this is why I bought a pan with a drain plug. Ugh
  16. K

    68rfe fluid and filter change

    Just did a trans fluid and filter change. Now I have codes. Fluid lvl is where it needs to be. Truck drives well. P0841 P0868 Drained overnight . O ring seal in good shape, left original in place, spin on filter on about 3/4 turn after mating surface seated, MOPAR RTV used. Also...
  17. K

    68 rfe fluid and filter change

    16 ram 2500 68rfe Just did a trans fluid and filter change. Now I have codes. Fluid lvl is where it needs to be. Truck drives well. P0841 P0868 Also interestingly I have codes for the turbo actuator that I had fixed 2 weeks ago. Were not there when I shut off the truck to do trans fluid and...
  18. K

    Less heat on driver side

    For those of you following this. I back flushed the heater core with hose water. Didnt use any chemicals. Hooked everything back up and I'm sweating now. Pass sude is up to 149 and driver side is 140 with ambient temp of 50. That's on the dash. MUCH MUCH BETTER. Guess either some...
  19. K

    Less heat on driver side

    Wish it was that simple.
  20. K

    Less heat on driver side

    My apologies. 16 ram 2500 6.7 Laramie auto 4x4. 140k highway miles. Little towin .
Back
Top