Search Results for Query: *

Thanks for the replies... seems that a squeeze and pull and it came right off... much easier than expected

Question- I need to disconnect and reconnect this a few times most likely. .. However I do not want to break it.. I have had limited success in the past not breaking.. If i understand correctly the tab in the middle would pull up and then it should come apart? Thanks....

put me down for another 06 bad tach... Happened around 65000

Mine just failed at 53K bearing went out. . Bypassed with non jake brake belt before it let loose. new pump from Geno's. . $359 Dealer $1200

ok. . well I just paid a few bucks for the new pads? I sent Geno's and email. . see what the deal is?

Thanks for the replys

3. a short pry bar will remove the caliper from the bracket. don't worry about bending the clips, new ones come with the new pads. I just got the new Hawk pads fro Geno's... . No clips?

Ok. . maybe it different on a 2 wheel drive? I look like the bottom of the caliper may want to come out first? Kinda wierd setup

I know it "should be easy" but it is not? I pried on it a little but it did not budge? Where do you pry?

Quick question... How does the caliper come off to remove and change the brake pads. . ? Do you pull those clips? On my 94 you just lift the caliper up and thats it... THanks for the help

Did you ever find a good write up? I went to do mine today and could not get the caliper off. . ? It appears that there is a metal clip that holds it on once the bolts are out? Came right off on my 94 the 06 is different... How do you remove the caliper?

2006 Seats suck, Blend-door brakes , dealer covered both under warrenty more than once for me... 35,000 miles. .

My seat failed at 30,000 miles. The metal is poking through the seat cover now. Dodge is replacing under warranty. The welds on the seat frame are sharp and cut the foam over time. Right now its like sitting on a sharp metal bar. . WTF

blend-door is a problem. . ask if it has been changed

still have not fixed it. . thanks for the tip's

THanks. . I still have not had time to get under there. . Maybe in a few days. .

I will take a close look. . If I put my hand above the pump it stays dry. . but below is leaking. . It looks like there might be a small crack in the pump? weird. that hole setup could not be in a worst spot to work on. .

I thought that fuel line also. But I can see the fuel dripping from the transfer pump not the back of the engine where the fuel line is? Have you heard of these pumps leaking before? I have not. Dodge want $309. Got one at the cummins place for $90

The truck has 104,000 on it and as I said it has the rubber fuel lines. It looks like the transfer pump is leaking. does anyone have a part number on the fuel pump?

I developed a fuel leak today. I appears to be coming from where the priming pump meets the block. Any thoughts on this. It only leaks with the truck running. I changed the fuel filter a few days ago, I thought that was where the leak may have been coming from, however I wiped the filter down...