Search Results for Query: *

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. K

    P0113 IAT HIGH VOLTAGE

    Yes it is reading true temps and it will pass smog!
  2. K

    P0113 IAT HIGH VOLTAGE

    He led all the harness found no problems. Disconnected the batteries, then unplugged connectors at PCM, they did not seem to be very tight. Applied dielectric silicone on connectors. Tightened them up reconnected batteries. Cleared codes and we seem to be good to go. Thank you. A new PCM would...
  3. K

    P0113 IAT HIGH VOLTAGE

    I will tomorrow thank you
  4. K

    P0113 IAT HIGH VOLTAGE

    Still get -40 do you think there is an open or the PCM is bad?
  5. K

    P0113 IAT HIGH VOLTAGE

    2004 3500 quad cab 5.9 automatic Replaced sensor twice to no avail. OBD reader says intake air temp is -40F. I live in the Mojave desert. Any ideas?
  6. K

    FASS for FREE Festivities! (Ends: February 28, 2010)

    Don't forget the special days and never take her for granted. Always open the door for her. Never hide anything from her this is your friend for life. I hope this will help you.
  7. K

    Archived 04 Died again today

    I will have to look up what you wrote. Thanks... ... ...
  8. K

    Archived 04 Died again today

    Yes, I am still in warranty. Unfortunately our local dealer closed up. Have to go 90 miles, that is why I pulled the tank. I wasn't sure i could get there. I am going to call them Monday on it. Thanks for the reply.
  9. K

    Archived 04 Died again today

    A fuel gauge is next on my list.
  10. K

    Archived 04 Died again today

    I finally had a chance to drop the tank. The filter screen and interior of the well of the fuel pump were plugged up with what appears to be thin sheets of plastic. The baffle in the tank appeared to be coated with the same material on the lower half of it or it is coming apart. Has anyone...
  11. K

    Ask an Engineer feedback

    I too would like manual hubs. I have laways had them on all my other trucks and really enjoyed using them.
  12. K

    Archived 04 Died again today

    My 04 3500 Quad cab 4x4 automatic 5. 9 HO died again today. This started back in May. When it dies normally I can pull over and prime the fuel filter by turning the key for 30 sec. s. Most of the time I do this more than once. Then it will restart. Some times it will keep running for along time...
  13. K

    Fuel problem?

    I have cleared all the codes. I did turn on the key to actuate the lift pump and inspected the fuel system could not find any leaks. i have not checked the relief valve yet. i will do that tonight. Since clearing the codes I have driven it another 100 miles with no problems. Thanks for your ideas.
  14. K

    Fuel problem?

    My truck died Sunday. After priming the filter I was able to get it started again. I was able to pull the following codes P0088 fuel rail pressure signal above maximum limit, P0148 high-pressure common rail (HPCR) check sum and P0483 fan speed. This is the second time in 2 weeks this has...
  15. K

    Lift pump problem??

    Lift Pump problem? My truck died today. After priming the filter I was able to get it started again. I was able to pull the following codes P0088 fuel rail pressure signal above maximum limit, P0148 high-pressure common rail (HPCR) check sum and P0483 fan speed. This is the second time in 2...
  16. K

    My 2004 3500 5.9 recently quit while driving home. The trouble codes that i pulled were P0088...

    My 2004 3500 5.9 recently quit while driving home. The trouble codes that i pulled were P0088 fuel rail pressure signal above maximum limit, p0148 high pressure common rail (HPCR) checksum and P0483 fan speed. Any ideas on what is the problem?
  17. K

    HVAC Removal with Pictures

    Thank you, I found it very informative as my recirculation door broke last week.
Back
Top