Search Results for Query: *

Thanks Prarie dog, I appreciate the explanation. I've come to realize this truck isn't as simple as my 96 in most ways. Thanks again and take care

Thanks for confirming what I was already thinking it may be.

Anyone have any luck diagnosing a p2127 code. I'm not noticing really any throttle issues and the truck is flashing the code when cold. I've just reset the code and will see if it flashes again. I'm assuming from what I've read its probably time to change the APPS out. Any thoughts on this...

It is a very sensative throttle, I can drive the truck and yes with the foot on the hump method. I've owned this truck now for 14 years and am fairly comfortable with it. It's pretty funny to watch others drive it though. I modified the pump and installed the new governor springs and such. When...

Thanks good point. When I originally posted this I had forgot what the code actually was. Turns out to be a P2607 code. The positive side of the relay coil was the culprit. It was a loose connection creating an intermittent problem.

Hope one o you can help with this issue, also hope non of you have it occur. I have a 96 with the NV 4500, worked over pump, plate, ht3b turbo, ceramic clutch. This is a one owner truck meaning that not many people can drive it. The throtte is extremely touchy and will start hopping violently...

Sorry for the delay but I wanted to put this issue to rest. I did find the cause of the code. Turns out that the wire that activates one of the solenoids was fairly loose. This created an intermittent problem which I was able to finally find with all your help. Thanks for the suggestions and input.

On my 96 I didn't spend anywhere near the 2K you mention. Of coure I did mine a little different and used 96-97 ford Dana 60 knuckles and rotors and then fixed the sleave on the vacuum operator for the passenger side axle shaft. This accomplished a couple of things which I was primarily after...

WEll it's been a few weeks and still not resolved what causing this. I am getting a low circuit code on the air intake, I'm going to try checking the sensor and cleaning to see if that makes any difference. Above 40 since I posted originally and not haveing any issues with it this time. I've...

forgot tp mention you may want to check and see if your tie rod assembly was on recall. My truck is an 04 and it was. Also best price I found was from Mopar supercenter on the East cost.

I would plan on replacing them with a free wheel set up as you're doing this. The unit bearing seizes to the assembly and you'll likely damage them taking them off in the first place. I tried multiple pullers as well as a penetrating oil and some heat the end result was pulling the outer...

Thought I would give a quick update to this. I did run the data logger over the weekend and didn't notice any noticable temperature differences in the intake air in comparison to outside air. I'm going to check the grid more this weekend and see that it is actually getting power and trace...

thanks I'll check that and post back later this week with what I find out.

I'll have to plug my reader into again but if I recall the text is cold charge air temp or cold intake temp. Also the grid heater is working fine I've had the horn off and checked it a couple of times and it definately works.

Typically anything below 35-40 and I start seeing it. The colder it is the longer it lasts. It also will do it after it's been driven for a while. In fact the other day 34 degrees outside, started the truck and let it warm up a bit. drove it about 20 miles shut it off at operating temp. Started...

Thanks guys The code's don't really bother me much but the lack of overdrive does when it occurs, Problem here is it keeps me from driving the truck for a few months unless I block off the grille area as suggested. I actually had the problem with the factory intake on the truck as well. I do...

Sorry if this question has been asked and answered before as I'm new to the forum or any forum for that mater. I have an 04. 5 that has a MAC air intake and pusher intake horn with an EDGE juice and 5 inch exhuast Aero tech muffler. As you can see pretty tame in comparison. The truck has 90 k on...