Search Results for Query: *

Anyone know the part number for the tie rod end that is needed ? Thanks and be safe

Found one ! There are pieces of pipe available with two 20 * offsets also . I may purchase 2 of these in 3 in stainless and tig them together . I’ll keep you posted how the stainless works it I choose that direction . Thanks and be safe

I’m having a hard time locating a new 3in exhaust pipe the goes from down pipe to extension pipe to muffler . The pipe with strange bends to clear the transfer case is what I’m in need of . Any help ? Thanks and be safe

Mine does raise , my old 4BT increases timing until warm .

I chased a leak and replaced rear main seal . Only to determine dip stick tube had a small unseen crack , causing the leak . Huge amounts of boost cause strange leaks

Thank you so much for the info . That plug is used on a second gen Dakota somewhere . I had a salvage I rebuilt years ago , and in the parts box were 2 of the correct plugs .

Anyone know the correct rubber plug part number for the holes in the rockers ? Thanks

I tossed unit bearings , to free spin , well well worth the investment

I swapped my box to early pre 79 style reverse steering box while I was changing steering boxes . Early style is much better design , much less stress on the frame also .

My edge keeps dropping high fuel log pressure code . I contacted Edge , my answer , sorry . We will give you money off a new EDGE ($100.00 ) . No thank you , you know there is a known issue , it should be free replacement .

My 05 has 39K on the clock sitting in a controlled garage , rear caliper piston stuck . I’m thinking as suggested , you have a caliper issue . Maybe a hose also .

I did mine with a hole saw as suggested . Somewhere I had read to use a ford hub cap they will work . But never tried on after drilling mine . If you try one please keep me posted if it works , thanks

I’m just the opposite I guess from most , I want greasable joints . My truck has free spin hubs and greasable joints anywhere I replace them . If you install 45* fittings on the CV , greasing the joints are a bit easier . Use the straight fitting and take it down spring and fall grease the...

Here you go Cummins Powered , NV4500 and NP205 , Dana 60 front and rear with power locks both ends .

My 05 will start and run with a Hardware store key No CHIP , just a standard old style key

Heat it up with a heat gun to soften it up

Thanks so much . I’ll look into these . Mr.Brockman , if you locate any please let me know also . Thanks so much for the help , be safe

I’m sorry , I’m 30 miles south of Cincinnati , Ohio . Again I’m so sorry , be safe

I’m in need of a set of rear overload springs , spacer blocks , frame stops . Anyone have any they want to part with ? Please PM me . Thanks and be safe

I worked as a mechanic at a Dodge dealer in 1979 . I put two of these new on the road to one owner , Carlisle Crane Co. . They were both Red , both same exact truck . Dogs delux , but probably way more scarce than any other Dodge pickup of the era .