Search Results for Query: *

Warmed up a bit and got everything together with a new battery. All seems good.

Agreed on the volt meter. Normally do this, but I knew these trucks take a while to activate the alt. It was cold and I was rushing so I went inside for a bit. Got a new battery yesterday. but it didn't get above 10 degrees so it can wait another few days until it warms up a bit. I am...

Well, I figured out what I did. Now the question is what other damage did I do? I forgot to reattach the cross over wire to the drivers side battery. I had folded it back on itself and it was on the aluminum valve cover. So, problem 1, I assume the computer was telling the alt to charge...

2003 on the operating table here. Had to buy new batteries cause a friend who borrowed truck left ignition on, killed batteries and then they froze. Finally got them. Got installed correctly. I know it is a question someone will ask. Started and let run for a half hour or so. I go out, hop...

I have reached out to a place inOH and TX that supposedly makes these things with no response from either. When I walk into my local dodge dealer I will need a part number or they will be a monkey doing a math problem. Anyone have one?

I was looking at what appears to be the tank vent. There are two front and rear with a plastic barb fitting, but no hose on them. When it stops raining I am going to take a better look and if it is what I think it is, install hose on them.

Center of cup to center of cup is 71 1/2

I just went and measured mine. I am 78 1/4 inches from the front of the flange on the diff to the rear of the seal where it seats against the tail of the t case. Hoping I can just buy from Dodge. Seems price listed elsewhere is resonable?

Well I found 22.5 traction rubber at a good price on ebay. Called centramatics and they directed me to Tow Brothers on amazon. 175 vs 215 from centramatic Got shocks and other maint items coming from genos garage. They are getting high in price these days vs local parts house. I always like...

4x4.

Morning all. I am on the hunt for a single piece DS. I have a 03 Crew long box dually. I keep going through carriers. At least 1 a year. two this year! Am I too long for a single piece? If not can I go the mopar direct drop in route? Part number please?

Getting to fixing my wifes cusomization of the bed side. Bed is off and I see I need some stuff. Where should I be headed to find the following. 1. Single piece drive shaft. Been through too many carriers in the last 4 years. I am done with it. Last two carriers have only lasted 5k each...

Thanks to my $%^&*( wife my drivers side bed side is trashed. I think it will be easier to buy a whole bed and just swap/paint vs cutting in a whole side and replacing fender etc. Anyone know of a damage feee, rust free preferably black gen 3 dually bed?????

Replaced sensor and code is gone. So bizzar that it failed upon just moving it.

I didn't disconnect. It has been zip tied to my large excavator air cleaner for 7 years. I had to move it around but that was it. Tried cleaning, etc. If I clear code with smarty it is back immediately. Just strange that it could fail like that. I checked voltage with a multimeter while...

None. Smooth as it should be. After I figure out the rest of my alt issue on my last day of driving yesterday I am going to video the shaft and see If it is moving arpund.

So after a very long couple of weeks I was on the road again. CityDiesel got the trans out. There was still material on the clutch so majority of the problem was the leaking rear main which just showed up as well. The pilot bearing was gone. Only the race on the input shaft was left. Input...

Last day of our trip i see the alt is not charging. I got it home, and tested this morning. No charge at all according to the volt meter. I replace the alternator. Now I have a p0073 code. It is the air intake sensor. I can not clear it with the smarty. Seems awfully coincidental? I have...

If anyone wants to do some MC riding I am game. This area is my favorite place o ride for a few years now coming down to visit the In laws. Giving the bike a bath and a shine and a once over after bouncing around on the NY and Penn roads tomorrow AM.

Got to Vonore this afternoon. Unloaded and chilling with the fam. Dropping truck off with city diesel Monday so they can work it in asap. Hard way to spend money when I have the means to do this at home. My fault for going so long at 265k miles. Thanks for the reference. Hate having to...