04.5 - Hp?? - Tst + Ez

[turbo lcc]

What kind of HP will an 04. 5 with an EZ and TST stack put down? What level should the EZ be set to?

 

[jwilliams3]

I did 462hp with that setup EZ on level 3, TST on level 6.

 

[JJPage]

I put down 440hp 870tq TST 6x6 EZ 2, however that was the 5th run in about 5 minutes. The dyno operator could not seem to get the torque setting correct, the first run was 460 hp and each additional run the hp dropped?



I know you asked about a 4. 5 and I have an 03, but I could not be more pleased. This is most definitely a sweet stack . I have to get a transmission upgrade now and also something to keep my fuel pressure sufficient because during the dyno runs I was witnessing a hesitation on my tach about 2700rpm, I am pretty certain I was draining the rail.



Hope that helps!

 

[CBrabec]

I have the TST "twins" program/EZ stack. Even though I haven't had it dyno'd because of my stock transmission, (full DTT and FASS 150 pusher being installed in 3 weeks) the guys at DTT said I will be right at or above the 500 hp mark. I would suggest that you upgrade your turbo & transmission right away if you want to run this kind of power. I blew my stock turbo within 2 hrs. after install. After those two are done, have fun!

 

[KevinO]

with my mods listed i put down 491 I have the old twins program. i was running the rail out of pressure so that is the best i could get.

 

[JVolpe]

My 04. 5 with FASS, SPS66, TST(w/twins) 7/7 and EZ on 3 dyno'd 498 on one DynoJet and 503 on another.