05 2" coil spacer?

[TFarrell]

this is my first post as im new to trd but here we go. I bought the tuff country 2" leveling kit/coil spacers. once i removed the shocks and the shock towers it says to mark the springs and just let the jack down until i can pull the coil out and then let it down enough to put the spacer on and reinstall the coil and shock tower, shock. when i let the jack down it didnt even go down enough to take the coil out let alone fit the spacer and coil back it. then i read another set of direction online that says "remove the nut and hardware from the anti-sway bar at the axle. im not sure exactly what that means becasue the sway bar is connected at both sides and im not sure if they mean the track bar. any help would be greatly appreciated. :-{}

 

[Jason Hughes]

You will want to remove the end links on both sides of the sway bar, loosen the control arm bushing bolts (you do not have to remove them), and if the diff won't go down enough after this remove the track bar bolt at the frame. The diff should then travel far enough down to put in the spring and spacer. Once you have accomplished this jack the diff back up, put in the shock bolt, bolt the wheels back on, lower the truck on the wheels to ride height, connect the sway bar links, tighten the control arm bushings (hopefully you marked where the caster cams are positioned), then install the track bar ( if it does not line back up, start the truck up and turn the wheel to the left until you get the bolt to line up). Re-check your install and you are on your way. Good luck.