1 in lift blocks

[Bunn]

Does anybody know who makes a 1 in lift block for the rear of an 03? I guess that the dimension is 6x2. 5x1 with a 3/4 inch center pin.

 

[CIverson]

If you have a 4x4 then buy the superlift 2" block kit and take out the 2 factory 1/2" blocks and wala you get 1" over stock.



If you have a 2x4 then forget what you just read.

 

[Bunn]

CIverson-



the factory spacer blocks... are they just sitting there, or are they bolted on or how are they attached to the leaf spring?

 

[CIverson]

They are just sandwiched between the axle and spring.

 

[nickleinonen]

can those 2x 1/2" factory blocks be removed easially to lower the rear down a bit?

 

[CIverson]

I've suggested that before and don't see why not, shouldn't change the d-shaft angle much. Not sure but I think the u-bolts might not have enough thread on them to tighten again so you may need new ones.

 

[Bunn]

Not sandwiched, they are part of the leaf spring. I couldn't seperate them.

 

[CIverson]

I couldn't remember exaclty from when I did mine, but in that case then it should be a simple matter of removing the center bolts to get the blocks out.