Here I am

11 volt parastitic draw ?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

1st gen dodge truck with 2nd gen seats

1st Gen Fuel Solenoid Wiring Question

Status
Not open for further replies.
Guys now, I have an 11 volt draw/short on my electrical system. after pulling all the fuses unhooking everything, AND ITS ALOT IN A TOOL TRUCK. iT IS MT STARTER OF ALL THINGS PULLINT THE 11 VOLTS? Weird?

Ryan


Wibndings Big Papa, I rebuilt it myself ! works great except! lol
 
What do you mean by 11 volt draw? How are you measuring that? I doubt it would be the starter. Should be no connection past the post on the starter solenoid until you activate the starter.
 
What do you mean by 11 volt draw? How are you measuring that? I doubt it would be the starter. Should be no connection past the post on the starter solenoid until you activate the starter.
You are correct, Part of it us my high dollar kenwood car stereo. I also have fosgate thousande watts per channell going to four six by nines and two 15 inch woofers. All monster wire installed under the shelves ported in my tool truck! I run 7 batteries so electral problems suck. Electronic train horn contoller 3 volts, ill measure the amps here in a sec.
 
Draw must be checked in series with an ammeter or at least a test light.Voltage can be measured even when there is no draw
 
Status
Not open for further replies.
Back
Top