2"x1 1/4 Shank Hitch Ball Source

[MIKE GOLF]

I recently purchased a new draw bar for my factory hitch and it has a 1 1/4 hole in it, does any one know a source of a 2" hitch ball with this size shank? I have located some but they have low (3500lb) ratings, looking for about a 10k rated hitch ball. thanks

 

[DennyDay]

Hitch Ball

A two inch ball is not rated for 10k --- you must use a 2 5/16 with an inch and a quarter shank. There are 2" inch balls with a 1 1/4 shank You can find one at most trailer places. There is one on I 35 up near Waco or check with Barry on this site, he is up close to Ft. Worth.

Denny

 

[Eric_77]

I have one in my garage I will send you for tyhe cost of shipping. I switched to the Adapt-a-ball system and will never use it again. Chrome is still in good but not great shape scratched but not peeling. I think the rating is 7500# but could be higher.

 

[Murle]

Try any TSC store. ( Tractor Supply Company)