4 gauge A pillar

[dclassens]

I know I know I know, this may sound stupid, or draw but I think it may look neat and innovative to CRAM 4 gauges on the a pillar. any ideas photos or info would be great. thanks

dave

 

[wildmanben]

I thought that 3 was bad enough to look at.

 

[WUnderwood]

I think that they only make 4 gauge pods for Powerstrokes

 

[SHobbs]

Made my own quad A pillar mount. My fourth gauge is in a bullet mount which is attatched to the center gauge which puts it in the same line of sight as the top gauge on the triple pillar. I have had no issues with view obstruction out of the windshield. I will get a pic of it tomorrow and post it.

 

[dclassens]

shobbs, I would like to see a photo if you have one,... thanks to everyone else for the info!

Dave

 

[SHobbs]

Got the best I could, not to bad with a camera phone I guess. It is hard to tell from the picture but, my fuel pressure gauge in in the bullet mount. The fuel pressure gauge is the same level as the top gauge in the triple pillar mount when looking out the windshield. Like I said I have no problem with this setup and have had it this way for about 2 years.

 

[dclassens]

Thanks a bunch!! I may try something like this.

Dave

 

[SHobbs]

Dave,



One more thing, the bullet mount has 3M tape on the base, it is not enough to hold it in place. I used two small screws to help hold it there.

 

[BBlyman]

I can't remember where I saw one, but someone made a 4 pod gauge that went just below or above the mirror. I thought about getting it.



Bob

 

[CDonaldson]

I found it at www.dieselmanor.com/pillars_pods/gauge_mounts_overhead.asp



CD

 

[edgerat]

don't use those overhead ones. I have never seen one stay in place longer than 6 months. If it were me (and it will be soon) I would run the 3-gauge a pillar and then run the 3-gauge pod on the dash if you need more gauges.