Competition 4 link plates for a Dana 70

[ob1kobi]

Does anybody know of a person, or place, that makes the axel plate used in a 4 link setup? I am about to do some work to mine and would rather buy the plates instead of make them if i can.



Thanks,

Ted

 

[JWilkinson]

Art Morrison

 

[steveinaz]

http://www.crawltech.com/

These guys sell all kinds of neat stuff. I've used them . SteveinAZ

 

[COMP461]

S&T water jet can shoot any thing you can draw 940 851 8055 mat or stan

 

[btanner]

bluw torch fab I think has some



-ben

 

[ob1kobi]

Thanks for the replies. I was hoping to find somebody who already made them, so I could just purchase a set, but I guess that was wishful thinking.



Thanks,

Ted

 

[btanner]

what size are the tubes on the 70 I assume that they are the same as a 14 bolt so this would work if that's the case

http://www.bluetorchfab.com/oscomm/catalog/product_info.php?cPath=24_48&products_id=116



-ben

 

[ob1kobi]

I am not sure exactly what size the 70 tubes are. I checked dodgeram.org bit they don't mention anything about the axel tubes themselves. Maybe they are the same?



Thanks,

Ted

 

[btanner]

measure them. The 14 bolts are 3. 5 inches so measure the outside diameter that should answer your question. I know that most of the older 1 ton axles all have 3. 5 inch tubes but I really haven't messed with the newer stuff.



-ben