Here I am

Engine/Transmission (1994 - 1998) 47RE conversion?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Engine/Transmission (1994 - 1998) Bellhousing bolts

Engine/Transmission (1998.5 - 2002) ecm needed

Status
Not open for further replies.
Hello,

I am thinking of doing the same,been told that the output shafts and overdrive housings from a 518(46re) are the same.

The overdrive clutch count does differ.
 
it is an easy swap, if you have an overdrive section from a 4x4 47re 96 and up. 94 and 95 has a 47rh which has a governor in ihe overdrive housing and wont work unless you remove it. you will also have to measure the assembled height of the overdrive clutch pack and may need a different thickness shim on the overdrive apply piston. i have a chart somewhere with the measurements and the part numbers for the shims. or you could use the shim from the 4x4 donor if its available.
 
Status
Not open for further replies.
Back
Top