4bt and Industrial Injection PS62/12

[KKunz]

I have a 4bt in my cj-5 I’m wondering how well it would work with an Industrial Injection PS62/12 turbo I have a brand new one that I have no use for and was thinking of putting it on when I upgrade my injectors it has a hy35 on it now maybe a hy-35 and II62/12 in a twin setup?

 

[GDMRTN]

Curious how the hy-35 works for ya? I want to try a hy35 and a pro52 sometime.

 

[DCreed]

unless you've got alot of fuel/rpms the 62 is too big for a single and too small for a lower on twins.

 

[fox]

The 62 will will support what, maybe 500 hp?

It should work good as a primary on a 4bt twin set-up.

How do you like the hy35 on that 4bt? What power level is it at now/

 

[zstroken]

I would use something a little larger on the bottom, at least get a 14 cm and the larger turbine wheel. What about really be a good one would be a prostreet 66 with a 16cm turbine housing.

 

[KKunz]

I have not had a lot of time driving the jeep since it has been done but the hy-spools much better than the stock bread truck H1C/16. The reason I was thinking of putting on the IIps62/12 is that for that reason the stock H1C is a 16cm and the HY-35 is a 9cm than the 12cm should be a pretty good compromise between the two but I must be missing something

 

[willyslover]

so try it and report back. . only cost ya a lil time and gaskets



any info laying around the net on the install ??

 

[Forrest Nearing]

I've got an S200 at the house that needs a new home. Was going to do an S200/pro street 66 twin setup on a 4BT for a buddy, but the project got cancelled