4WD Service message/ABS/Traction light

[monovasia]

2012 2500/6.7... Truck was at the airport sitting for 5 days, started her up and the above popped up on the dash...Current mileage 125600

Differentials and transfer case service June-2021 @ 108k
4x4 Service ( which seems the same as above) @ 69k

I did run in 4wd more than usual this past winter, but no where near significant distances not time...

Is this a "60k"interval service that was entered wrong at 108k and is it common for the ABS/Traction light to come on with this service message?

Thanks to all in advance for the council and recommendations...

 

[monovasia]

2012 2500/6.7... Truck was at the airport sitting for 5 days, started her up and the above popped up on the dash...Current mileage 125600

Differentials and transfer case service June-2021 @ 108k
4x4 Service ( which seems the same as above) @ 69k

I did run in 4wd more than usual this past winter, but no where near significant distances not time...

Is this a "60k"interval service that was entered wrong at 108k and is it common for the ABS/Traction light to come on with this service message?

Thanks to all in advance for the council and recommendations...

UPDATE:
I scanned her and it shows a right rear wheel ABS sensor failure... which I would think would cause the other 2 service and failure alarm...

 

[brucejohnson]

UPDATE:
I scanned her and it shows a right rear wheel ABS sensor failure... which I would think would cause the other 2 service and failure alarm...

Had similar indications on a Jeep Patriot, which played havoc with the transfer case, too. (AWD system automatically disabled due to bad wheel speed sensor) Changed rear wheel speed sensor and all is well.

 

[Topzide]

This is why I love having AlfaOBD and a Bluetooth dongle! I can scan wherever I'm at. Has saved me a lot of aggravation and time in finding out what has gone wrong or just gremlin!

 

[monovasia]

UPDATE: finally caught some time to address this... Mopar parts back ordered went with a " standard" make sensor... the OEM was repaired !!! when I pulled it, probably damaged a while ago (electrical tape and silicone )...

replaced the sensor... rescanned all fault cleared... running fine... thanks for the support as always