A-pillar dual gauge mount

[mattymac]

Ive been looking around and I cant find the Add on dual gauge mount that just attaches to the A-pillar. I dont want the full dual A-pillar mount just the Add on piece that goes over the stock pillar that measures about 10 or so inches. Also if someone already has this can you get the exact measurement from the top to the bottom of the mount. Thanks guys.

 

[ScottBrown]

Why not go with the full mount. It would at least give you some room for the wireing and would look a lot cleaner.

 

[Mark Craig]

mattymac,



This is something that might also help you, it's factory Taupe color matched and grain matched, and replaces the factory pillar on any of the 2003+ trucks and has provisions for 2 or 3 gauges. You don't have to cut up your factory A pillar and grab handle, just take it off and put it on the shelf, screw this one the the truck and drive! Check the pictures.



Mark @ DPPI



Pic's finally:



https://www.turbodieselregistry.com/forums/attachment.php?attachmentid=48374

 

[hasselbach]

pictures??

 

[mattymac]

Thanks for the help guys! But my problem is that I already have the "full 2 pod pillar mount" I seen a truck that took a tripple Full pillar mount then put the single pillar pod add on mount to have 4 gauges down the pillar (looked sweet) Thats why I put in the post above that "I would also like the measurements from top to bottom of the mount" to see if it will fit. I see everywhere the single add on pillar mounts but the dual would at least look a little better and I dont want to drop more money on a tripple pillar mount then get the single if I dont have to.

 

[Mark Craig]

hasselbach,



I have tried to add the pictures, the system says it's been added but darn if I can find them, any help out there??



Mark @ DPPI



Try this link, maybe this will work!



https://www.turbodieselregistry.com/forums/attachment.php?attachmentid=48374

 

[ScottBrown]

try this

https://www.turbodieselregister.com/user_gallery/displayimage.php?&photoid=4773&width=0

 

[AndyMan]

try this

https://www.turbodieselregister.com/user_gallery/displayimage.php?&photoid=4773&width=0

Scott. It appears that the pic you posted is a two gauge pod WITH the grab handle?!?!?! Where can I find this wonderful piece!! I have the 3 gauge pod, and miss my grab handle.

 

[Rocket]

I think that's a three pod pillar.

 

[ScottBrown]

no it is just a 2 pod with no handle. Truck is a 6 speed

 

[Rocket]

My bad, I looked in the wrong reader's rigs... but I looked at yours' just now and that Moose Hunting Ram is awesome !!!!

 

[ScottBrown]

Thanks. It is that time of year again