ABS & Brake warning lights on, no dtc and no other issues - is there a reset?

[ghputnam]

is there a reset for this - I know the e-brake is out of adjustment, is there a correlation?

Where do I find e-brake adjustment procedures? std brake spoon tool won't work with spring in the way on 1 side

 

[rscurtis]

The ABS system will not set a code when malfunctioning. You can ohm out the sensors at the ABS unit. Let me know if you need the wire locations for each sensor.

 

[jelag]

We don't know what year of truck you have but I can share that my BIL with an 03 dually had an open sensor and it set both lights... we ohm'd out the sensors and found the bad one... . replaced it and all was good.....

 

[ghputnam]

Thanks rscurtis & jelag, I could use the wire locations.
By the way, it's an 07 w/ 6. 7

 

[jelag]

We went to each wheel, disconnected the ABS sensor and put an ohm meter on the lead going to the sensor... an infinite (open) indication on the ohm meter is a bad sensor... . I can't remember the ohm meter reading on a good sensor, but as I remember it was a few ohm's... for us... as we wiggled the wire the ohm meter would change, thus indicating a broken wire... .

 

[ghputnam]

Thanks a lot,
Geoff

 

[timelessconstructionllc]

I had this same issue. It was due to the fact that I replaced the ball joints and u joints and when doing SO I FORGOT THR THE BRACKET THAT HOLDS THE WIRE FOR THE ABS SENSOR, thus causing a hole to get worn thru the insulation. Pulled hub, patched wires, now all is well. Hope this helps.

 

[ghputnam]

Thanks for the info