ABS module wiring connector pin #'s

[mtnranch]

My 2006 has the ABS and brake indicator lights on, intermittently. The AMP connector to the ABS module is clean with no issues and I'd like to ohm out the 3 sensors (2 front wheels and 1 rear diff) while it's currently in trouble.
Does anyone have the pin #'s or wire colors that map to the 3 speed sensors so I can ohm out the circuits from the ABS connector?

 

[mtnranch]

Geez... . TDR people a great resource on a common issue!

 

[jelag]

When my BIL had a problem with his truck we pulled the sensor loose from each wheel... we tested the senor at the wheel... we found as we turned the wheel from side to side the LF would go from an ohm meter reading to infinite (open)... once we replaced the sensor both lights went out... Hope this helps...

 

[sag2]

Wiring info

This should helpView attachment 2006 DR ABS module.pdf

 

[mtnranch]

Jelag, Thanks! Appreciate your response. Hey, PACBRAKE you sold me is working fine

 

[mtnranch]

Sag2, Now that's what I'm talking about! Exactly what I was looking for, Thank you. Will post my findings, gotta be one of the 3 sensors.

 

[mtnranch]

Victory! Used the ABS module connector pin diagram provided by Sag2, rear diff sensor was intermittent. Changed out diff sensor $21 from Napa and lights went out after 5 miles of driving. So if you change out a sensor, don't expect the ABS and brake indicator lights to go out right away, go drive it.
Thanks for your help