Engine/Transmission (1998.5 - 2002) air dog?

[Bob Cochran]

Wyomingcowboy- I left the OEM canister in but removed the filter from the can. I don't see a problem either leaving it in and you can always remove if it turns out to be a problem.

 

[bigredblur]

I removed the OEM filter can. It was easy to remove and I figured I might need to shove something down there at some point anyway.

 

[Wyomingcowboy]

Where and what type of fuel pressure gauge are you using? The air dog replaces all of the banjo fittings and the only gauge plumbing I have seen utilizes the banjo fittings in some way.

 

[Bob Cochran]

Before I put in the Air Dog I and installed the Vulcan 1/2" relocation kit and in the line they provide between the canister and VP has a place to connect the gauge. I am sure you can buy these in line barbed fitting easy enough though I have not tried if you want to remove the canister. I am sure somebody know of a source for this fitting. Oh by the way there is a place on the output side of the Air Dog for a switch to turn on a low pressure light. I wonder if that could be used for a connection for a fuel cause but it kind of a long way away.

 

[Cummins724]

I am sure you can buy these in line barbed fitting easy enough though I have not tried if you want to remove the canister. I am sure somebody know of a source for this fitting. .

Here ya go. Fuel Pressure Tee 1/2 Pushlock