Amazing Injector Puller

[Archive]

Saw the injector puller at Cummins, decided to do something similar but better.

Use a 23mm deep well socket! The injector pulls into it nice as can be and it's the perfect height to clear the valves and rockers. Place socket above injector; drop bolt through socket opening, crank down the bolt to lift injector into the socket. Presto.

 

[Archive]

Mark,

I made a slide hammer puller for my 93 and it worked good. Used a 1/2" fine thread bolt and nut and a 1/2" drive large socket. Slide the socket on the bolt to act as a slide hammer, screw the nut onto the injector, screw the bolt into the nut. Give the slide a couple of "whacks" and the injector pops right out.

Stan

[This message has been edited by paccool (edited 11-13-2000). ]

 

[Archive]

Jim Leonard also sells one that works great and I like to use it on #s 5&6 when doing a nozzle swap. Otherwise, I use the slide hammer tool from Snap-On. Ingenious idea, Mark.

------------------
Chris Timochko
1997 5sp 4X4, HX40, BD 4" Brake, Marine Compression, Custom Tuned Injection Pump, 370B Injection Nozzles, Delivery Valves, Governor & AFC Spring Kit, Psychotty Air, Water Injection, NOS Diesel Kit, 6" Chrome Exhaust System, No Smoke Valet Switch, McLeod Dual Disc Clutch, Mag-Hytec Rear Cover, Cummins Chrome Kit, Optima Red Tops, Hadley Bully Horns, Hurst Line Loc, Goodyear Wrangler AT/S 305/70/16s. Test mule for Auto Wurks Diesel race program