Here I am

Engine/Transmission (1998.5 - 2002) Another Fass Problem

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

2nd Gen Non-Engine/Transmission Aftermarket Fuel Gauge OHM question...

Engine/Transmission (1998.5 - 2002) 4 wheel low kit

Status
Not open for further replies.
Whats up yall!

I hooked my fass up through the window circut in the fuse block.

I had a pump go out and put the new brushless on and noticed it was alot louder, held higher pres. and sounded like it was moving alot more air.

Everything was fine the i realized today that i started the truck and the fp gauge dropped after a second and wouldnt start back but it runs fine if the truck isnt running? :confused: :confused: :confused: ????

any thoughts. whats the best power source, my factory lead wont hold a current eaither?

Thanks
 
LUnderwood said:
Whats up yall!
I hooked my fass up through the window circut in the fuse block.
I had a pump go out and put the new brushless on and noticed it was alot louder, held higher pres. and sounded like it was moving alot more air.
Everything was fine the i realized today that i started the truck and the fp gauge dropped after a second and wouldnt start back but it runs fine if the truck isnt running? :confused: :confused: :confused: ????
any thoughts. whats the best power source, my factory lead wont hold a current eaither?
Thanks
You only want to power the relay with the power window circuit. The power for the FASS should come directly from the battery, and be switched by the relay. You dont want to run the FASS directly from the PW circuit.

Maybe you are tripping the power window breaker by running the FASS directly from the circuit??

Just a best guess from my interpretation of your post. Any, and all details will help us figure this out with you.
 
Shortshift,

Thank for the reply! I'm running a relay and tripping of the power window. I rewired to a diffrent wire and im not having any problems now! My Factory lead would only start the pump and shut it back off! Now im wondering why its so loud... the sound varys like they say it will but its very loud! With 6" Pipes i can still hear the pump. If i crack the water seperator or filter it stops and sounds normal. Im thinking maybe somthing in the tank but it wasnt doing it with the old pump and im still running the 95. I'm going to try to get some good pics of my ride on here! Its really great yall have such a mass of really good lookin and runnin trucks!

Thanks

L
 
Status
Not open for further replies.
Back
Top