Anybody have a factory 24V tailpipe?

[243]

Need a 24V tailpipe for a longbed 4X4, preferably in Southeast Texas.

 

[Chipstien]

I have got one though since I am in Washington it doesn't do you much good.

 

[Gary - K7GLD]

If you have a local diesel performance shop available, check their junk pile out back - probably find LOTS of them!

 

[duaneparks]

243: FWIW, I called M&D (on N. Shepherd) and they didn't have any. There is another place though...



High Performance Diesel (281)345-4224



You may have other sources. M&D suggested checking the bone yards, but had no suggestions.



HTH.



Duane

 

[mgoncalves]

I just gave mine to my dad for his 93, Sorry.

 

[GBerry]

exh

sent ya a PM

I should have looked at the post didnt show any replys from the engine/drive train forum

simular senaro as Chipstien reply

good luck

Guy

 

[RustyJC]

I have the stock 2002 muffler/resonator assembly, but no tailpipe! Those LSTDR vultures grabbed that thing before we even had the Jardine 4" system completely bolted up on my truck.



Rusty

 

[Bill Lins]

David- I'll be installing my 4" system @ the bomb session later this month. If you can use my 3" tailpipe (12 valve, 2wd long bed) you're welcome to it.

 

[243]

Thanks Bill, but I'll wait until I find a 24V pipe so that I use the factory hangers. Will you be adding more fuel to go along with the 4" exhaust?

 

[gitchesum]

He will, he just don't know it yet.

You guys keep him near the back of the truck while I break into his pump and do a little tinkering. :-laf

 

[MCummings]

243,



I have only the section that goes over the rear axle and the tailpipe tip.



My truck is a '98. 5 3500 2wd. Let me know if you can use it.



Merrick Cummings Jr

 

[willyslover]

I have two of them... but their in Central Komiefornia close by Yosemite

 

[DWATTS]

Originally posted by 243

Need a 24V tailpipe for a longbed 4X4, preferably in Southeast Texas.

 

[ISBPilot]

will have to check.............

I should have mine left over from my stack job. It is down at my cousin's shop. It came off of my 99 24V cab/chassis long wheel base. Not sure if it is the exact pipe you are looking for. If it is you are welcome to it. Let me know and I can take some measurements off of it to see if it will work. I am located about an hour north of Lake Charles.



Todd

 

[243]

All, thanks a lot for all the replies. I will see if I can work something out with Merrick... .



... I will email or shoot you a PM.

 

[Grandpappy]

243, I have complete exh. system off my '01 3500 2WD,LWB. Very few miles too on it too but it is three (3) pieces due to 2 saw cuts. If you want it, give me a call at home.

Howard

 

[Bill Lins]

Originally posted by 243

Will you be adding more fuel to go along with the 4" exhaust?

But of course- the CORRECTLY- valved engines can handle it!

 

[243]

The search is off thanks to Grandpappy