Archived Anyone have a broken 1st Gen Rear Antilock Valve?

[TKirby]

Anyone have one of these laying around? It's the piece that fits in the frame rail on the driver side, above the rear axle. I'm in dire need of the brass output fitting that adapts the output brake line to the valve unit. It's the brass piece that has a 5/8" hex head (I think), and it has an O-ring and a machined section below the hex head region. My valve is still good, but the line was so rusty it's broken off and well beyond hope of ever extracting. (I had a machine shop try). I'm not quite ready to bypass the ABS quite yet.



Thanks

Todd K.