Here I am

Anyone running 245/70/19.5s on their gen 1?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Looking for AFC diaphragm part number...

Tire Clearance

Status
Not open for further replies.
My 8r-19.5's are just as tall as the 245 but they are about and 1.5 inches narrower then the 245's they are a close fit but I don't think the 245's would fit on my truck with out rubbing, but I have old kind of worn out front springs.
 
Hmmmm. Interesting. I have considered 225/70s but I don't like the aspect ratio. They look too much like a rubber band around a rim. And the 8Rs may look too narrow on the crew.

So in theory, the crew cab has a 1.5" body lift and a 1" actual lift.....in theory I should JUST be ok. Thoughts? Where would yours hit if they were wider? The fender itself? The edge of the lip?
 
First off I was wrong the other day they are 7" wide on the road, they would hit on the rear outer edge of the fender opening my 8's barely clear the aluminum front plates for my running boards.
 
Status
Not open for further replies.
Back
Top