2nd Gen Non-Engine/Transmission Anyone Using the Airsep for the crankcase vent issue?

[BILLVO]

I have had mine for 3 years and am as happy with it as I was on day 1 everytime I look at the bottom of my rig and see how clean it is. :



http://www.walkerairsep.com/product_detail.asp?id=439



It is a bit pricey but the benefits outweighed the cost for me. Especially since the vacuum pump seal was starting to weap and after installing the airsep has stopped that was 50k miles ago. The only issue I had was the custom oil fill cap started leaking under hard trailer pulling days, I called them and since I ran an aftermarket turbo with more boost they custom made another to compensate for the extra boost pressure. No problems since. There are pics in my readers rigs.

 

[BTowler]

Too much added hardware from the looks of it, plus looks like you have the potential to oil coat the inside of your intercooler and intake system (not a good thing). If you have any of your boots or your airhorn off, check for oil and post what you find, just for curiousity.

 

[BILLVO]

Too much added hardware from the looks of it, plus looks like you have the potential to oil coat the inside of your intercooler and intake system (not a good thing). If you have any of your boots or your airhorn off, check for oil and post what you find, just for curiousity.

Absolutely no oil in intake I have done 2 turbo changes and it is clean. The design of the filter cartridge will not allow oil to enter the intake system. I agree it is bulky but there are a lot more benefits to it than just the drip stopper.