Here I am

Engine/Transmission (1994 - 1998) are 12 valve tps's adjustable?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

2nd Gen Non-Engine/Transmission NOAH truck covers

Engine/Transmission (1998.5 - 2002) Recurring Codes

Status
Not open for further replies.
my trans shifts into 3rd by 20mph and locks the t/c by 50 mph with no downshift or t/c unlock when i floor it. the tps wasnt turning when i hit the throttle, so i fixed that, but it still shifts too fast and the tv cable is at max adjustment. is the tps bad or is it out of adjustment? 96 ram 2500 4x4 new trans and goerend low stall.
 
Last edited:
They can be adjusted. Trying to find the specs and test procedure. On here or some other site... ... ... ... ...

Edit- Just noticed your engine. Do you have the VE or swap in a P-pump on that engine?

For the '97, The voltage at the TPS should be 1. 0 volt (+ 0. 2 volts) with the linkage in the idle position. At Wide Open Throttle (WOT), the output voltage of the TPS must be 2. 2-to-2. 9 volts higher than at idle speed. If voltage is not correct, recheck the linkage adjustment.

Recall #B15 - Diesel Engine Throttle Linkage

Or, for the VE-

28. Vehicles equipped with automatic transmission only: Check and adjust the throttle position sensor (TPS) as follows (Figure 27):

* The injection pump throttle lever must be in the low idle position and the throttle lever must reach breakover when the throttle is wide open,
* turn the ignition key to the ON position,
* connect the negative lead of the voltmeter to a good ground (1991 1/2 - 1993 models may use DRB II),
* insert the positive lead of the voltmeter to the center (output) wire of the TPS electrical connector (leave connector attached to TPS),
* with the throttle lever contacting the low idle screw, the TPS output voltage should be 1 volt ± 0. 05 volt,
* adjust the closed throttle TPS setting, if required, by gently rotating the nylon adapter until the correct voltage is obtained,
* open the throttle lever to the wide open position,
* the TPS output voltage should increase a minimum of 2. 25 volts from the closed throttle position voltage.
* if TPS required adjustment, disconnect the battery negative cable for 2 minutes to reset adaptive memory, then reconnect the battery.

Recall #605 Diesel Fuel Injection Pump
 
Last edited by a moderator:
Status
Not open for further replies.
Back
Top