Engine/Transmission (1994 - 1998) Banjo bolt size Fuel Supply Line

[billkocher]

Hey there, I seemed to have dropped (and lost) the nut that threads into my 95 Ram. I have the banjo bolt that is on the "top" but not the one that it "threads into" from there.

There is a fuel line from the transfer pump that threads right into the fuel filter housing (which I lost) and then another banjo that threads into that which runs to the fuel drain manifold (which I have)...

Does anyone know what this bolt is called or a part number or size or anything???? Thanks!#ad

 

[BigPapa]

Well, it's not just a nut, it's a banjo bolt, number 4 below. Number 5, the check valve, screws into it.

 

[billkocher]

Thanks a ton, that is exactly what I was after!

 

[mwilson]

You should also get new sealing washers while you are there....

#3 and #6.....

Scott and Bill, ignore the previous drawings that I deleted. I was focused on the forward fitting rather that the rear fitting. I need way more coffee apparently......:{

 

[BigPapa]

Hey Mike. That is the one on the left looking at the filter drawing he posted and it does have the 6mm bleeder bolt. It's for the IP supply line. The one on the right is the one I posted and it's for the injector return line manifold and has the check valve on it.

As I'm sure you could tell, I "made" the drawing I posted from a couple of different drawings.

 

[mwilson]

I caught my mistake right AFTER I posted it.... Knew there was no stopping the notification so I edited before it went too far...

I have to do payroll now and I better get it together.......:-laf

 

[GAmes]

billkocher , if you take a few minutes to register with Cummins Quickserve you can easily find all your engine parts and will not have to rely on someone to find your posted question.
http://www.cumminsforum.com/forum/94-98-powertrain/1867106-cummins-quickserve.html

 

[BigPapa]

But then I won't have any fun Gary......

 

[GAmes]

I wouldn't either, but eventually the chicks have to fly.

 

[billkocher]

billkocher , if you take a few minutes to register with Cummins Quickserve you can easily find all your engine parts and will not have to rely on someone to find your posted question.
http://www.cumminsforum.com/forum/94-98-powertrain/1867106-cummins-quickserve.html

Thank you, I was going to ask where you found that drawing with part numbers. Thanks everyone

 

[mwilson]

Thank you, I was going to ask where you found that drawing with part numbers. Thanks everyone

Bill, QuickServe is having issues today. I will keep you posted as the day goes on.

I will send you the direct registration link when they have it up and running again.

 

[BigPapa]

I know it was down yesterday but mines been fine today.

 

[mwilson]

It let me in right up until the registration portal....been screwed up on and off for about two weeks now...

Scott, here is a second way to get in. I used it yesterday as a workaround....it worked when the other portal was down...

https://qsol2.cummins.com/cola2/login/index.html

 

[BigPapa]

I'll try it next time it's down. Thanks.

 

[mwilson]

Just got this from Cummins...