Here I am

Bed Re-wiring problem

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Banks Power

So many rookie Q's so little time (2nd Cruise Control)

Status
Not open for further replies.
My project id progressing. I picked up my flat-bed replacement last week. It is a '93 1 ton dually bed. Here is the problem. The bed is in great shape, the wiring harness however is shot. Anybody have an idea where I might find a replacement? I have been checking salvage yards but one for that era truck is hard to find. :(
 
Check your local NAPA store. I know the tail light sockets you can get from there. If you can get the backups. I would just build a new harness. Just buy the same color wire and run new. Solder all connections and use heat shrink on the splices. Buy some wire hangers and secure it the best you can.



I wish you would have posted and said something about wanting a dually bed. I have one I would have traded for a good flat bed wide enough to cover the wide dually axle.
 
Status
Not open for further replies.
Back
Top