Blocks

[MRosinski]

Has anyone put a 3" block in the rear to get some lift? Is a 3" block going to give me alot of axle wrap?? I found some tough country cast iron blocks, but am not sure if cast would be a good thing w/suspension. I plan on putting a revtek spacer in the front and a 3" block in the rear to keep the rear higher. All I want to do is keep the factory stance, just lift it up to clear 37's



Thanks.

 

[MRosinski]

This kit w/ a 4" block???



http://www.bds-suspension.com/php/ProductBase.php?kri=224H

 

[NKenny]

The stock 4" block already gives me more axle wrap and wheel hop than I can stand. Additionally, stacking blocks may present additional stability and safety concerns.



On my '01, I am looking to eliminate the block completely, even if it means a bit lower rear for a while. My concern is off-road traction as I am not working so much in this truck anymore. I would look for replacement springs or re-arch your current springs if possible.